Toshiba TV Regza XV55 series Power Protect Detection (Red LED 0.5-Second Blink)

What this problem usually means

On Toshiba Regza XV55-series TVs the red front LED blinking continuously on a 0.5-second cycle indicates power protect detection — the TV's protection circuit has shut the set down because of a power fault. The same condition is shown on Regza RV535U models as the green LED blinking quickly. Toshiba documents timing/rate patterns rather than Sony-style blink counts, and patterns vary by model and generation.

Likely causes

  1. Power supply board fault or protection trip
  2. Short circuit on a board fed by the power supply
  3. Overcurrent condition detected by the protection circuit
  4. Temporary power surge or glitch

How to fix it — step by step

  1. Turn OFF the TV and unplug the power cord, as directed in the Toshiba owner's manual
  2. Plug the power cord back in and turn ON the TV to see if the protection was temporary
  3. Try a different wall outlet directly, without a power strip, and disconnect all external devices before retesting
  4. If the rapid blinking returns immediately, stop power-cycling the set — repeated protection trips indicate a hardware fault
  5. Have a technician check the power supply board and the boards it feeds for shorts → Shop the power supply board at RepairClinic

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Toshiba TV Regza XV55 series problems

See all Toshiba Regza XV55 series codes & guides →