Toshiba TV Regza XV55 series BUS Line Error (Red LED 1-Second Blink)
What this problem usually means
On Toshiba Regza XV55-series TVs the red front LED blinking continuously on a 1-second cycle indicates abnormal operation of the BUS line (the I2C communication bus between chips/boards). The same condition is shown on Regza RV535U models as the green LED blinking slowly. Toshiba documents timing/rate patterns rather than Sony-style blink counts, and patterns vary by model and generation.
Likely causes
- Communication failure between the main board and another board or chip on the BUS line
- Failed main board
- Failed peripheral board pulling the BUS line down
- Corrupted firmware or initialization data
How to fix it — step by step
- Turn OFF the TV and unplug the power cord, as directed in the Toshiba owner's manual
- Plug the power cord back in and turn ON the TV to clear a temporary BUS error
- Disconnect all HDMI and other external devices and retest, in case a connected device is disrupting communication
- If the slow blinking persists, unplug the TV for several minutes for a fuller reset and try once more
- If it still returns, have a technician diagnose the main board and connected boards — BUS faults are board-level repairs → Shop the main board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the main board.
Parts that commonly fix it
- main board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.