Toshiba TV Regza XV55 series Initialization Error (2 Blinks, 2-Second Interval)
What it should look like on your machine
then it repeats
2 blinks - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
On Toshiba Regza XV55-series TVs the red front LED blinking 2 times with a 2-second interval indicates abnormal operation due to an initialization error — the TV failed to initialize correctly at startup. Toshiba documents timing/rate patterns rather than Sony-style numbered fault codes, and patterns vary by model and generation.
Likely causes
- Firmware or memory initialization failure at boot
- Main board fault
- Corrupted settings / NVM data
- Power interruption during a previous startup or update
How to fix it — step by step
- Turn OFF the TV and unplug the power cord, as directed in the Toshiba owner's manual
- Plug the power cord back in and turn ON the TV and allow extra time for boot-up to complete
- If the TV reaches the menu, perform a factory reset via MENU > Reset TV and complete the welcome/auto-tune setup again (Regza XV55 procedure)
- Disconnect all external devices and retest if the error returns
- If the pattern persists after a reset, have the main board checked by a technician → Shop the main board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the main board.
Parts that commonly fix it
- main board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.