Sundance Spas Hot tub 780 Series FL--1 Error Code
What the FL--1 code means
On Sundance Spas 780 Series hot tubs, FL--1 (FLOW ERROR OPEN) means the flow switch is malfunctioning open, the filter cartridge is excessively dirty, or an air lock has occurred at the circulation pump intake. The heater deactivates and Jets Pump 1 may also deactivate.
Likely causes
- excessively dirty filter cartridge
- air lock at the circulation pump intake
- low water level
- malfunctioning flow switch → Shop the flow switch at RepairClinic
How to fix it — step by step
- Verify water level is above all jets but below the lowest pillow and add water if needed
- Turn power off and remove and clean the filter cartridge → Shop the filter cartridge at RepairClinic
- Purge the air lock per the manual: remove the filter, hold a garden hose sealed with a rag over the filter wall fitting, run water 30 seconds, then reinstall the filter
- If the circulation pump is not running, cycle power at the main breaker to reset its priming cycle
- If the problem persists, contact your Sundance Spas dealer or a qualified spa technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flow switch.
Shop the flow switch at RepairClinic or Amazon
Also tied to this fault: filter cartridge - Shop at RepairClinic or Amazon
Parts that commonly fix the FL--1 code
- flow switch - Shop at RepairClinic or Amazon
- filter cartridge - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.