Subaru SUV Ascent Fuel pump failure
What this problem usually means
Both 2019 and 2020 Ascents were affected by the Denso low-pressure fuel pump recall, in which the pump can stop working without warning. A failed pump can stall the engine abruptly, even in the middle of traffic, or leave the vehicle unable to start.
Likely causes
- failing low-pressure fuel pump
How to fix it — step by step
- Pull over safely if the engine stalls while driving, and do not keep cranking a car that will not start
- Note whether stalling repeats or the car cranks without firing
- Check by VIN whether the fuel pump recall applies to your Ascent
- Have a dealer replace the low-pressure fuel pump under the recall → Shop the low-pressure fuel pump at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the low-pressure fuel pump.
Parts that commonly fix it
- low-pressure fuel pump - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Subaru manual is on Subaru's support site — you'll need your model number.
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.