Speed Queen Washer FF Front-Load Er nF
What this problem usually means
No water flow error on Speed Queen front-load washers: little or no change in water level is sensed within 5 minutes of starting a fill.
Likely causes
- Water faucets closed
- Clogged inlet hoses or inlet screens
- Pressure sensor hose leaking, disconnected or clogged
- No water flowing into the machine
How to fix it — step by step
- Check both faucets are on and water is flowing
- Clean the inlet screens and check the fill hoses for clogs or kinks
- Unplug the washer for 15 seconds to clear the code and restart
- Call for service if Er nF returns, as the pressure sensor hose or valve needs checking
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water inlet valve.
Parts that commonly fix it
- water inlet valve - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Speed Queen manual is on Speed Queen's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.