Speed Queen Washer FF Front-Load Er dU
What this problem usually means
Door unlock error on Speed Queen front-load washers: the door will not unlock at the end of the cycle or when paused.
Likely causes
- Door lock mechanism jammed or failed
- Control has not finished draining before unlocking
- Failed door lock assembly
How to fix it — step by step
- Unplug the machine for about three minutes to let the lock release
- Make sure the washer has drained; run a drain/spin if water remains once power is back
- Do not force the door open
- Call a technician if the door stays locked with an empty drum → Shop the door lock at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the door lock.
Parts that commonly fix it
- door lock - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Speed Queen manual is on Speed Queen's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.