Sony TV 2 Blinks

What it should look like on your machine

then it repeats

2 blinks - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

The red standby LED blinks twice, pauses, and repeats, indicating a power supply board fault on Sony Bravia LCD/LED (KDL/KD) models. The TV's self-diagnostic system has detected a main power problem and shut the set down to protect other circuits. Blink meanings vary by model and generation, so always confirm against your exact model's service documentation.

Likely causes

  1. Failed power supply board
  2. Bulging or leaking capacitors on the power supply board
  3. Failed MOSFET or rectifier on the power supply board
  4. Short circuit in a circuit fed by the power supply

How to fix it — step by step

  1. Unplug the TV, press and hold the power button on the TV for 30 seconds, wait 2 minutes, then plug back in and try to power on to clear a temporary fault
  2. If the 2-blink pattern returns, unplug the TV and wait at least 5 minutes before removing the back cover
  3. Inspect the power supply board for bulging or leaking capacitors, burnt components, or heat damage → Shop the power supply board at RepairClinic
  4. Check standby voltage on the power supply board if you have a multimeter and are qualified to do so
  5. Replace the power supply board with one matched to your exact model number if the board is faulty — replacement boards are plug-and-play on most models

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Sony TV problems

See all Sony TV codes & guides →