Shark Robot vacuum AI Robot Series CLEAN (WHITE) + DOCK (RED) + ! (RED) flashing
What this problem usually means
Error number 2 in the Shark AI Robot (RV2500/AV2501-series) manual: wheel motor encoder failure. Shown by CLEAN white, DOCK red and ! red flashing. The manual's solution is to contact Shark Customer Service — there is no DIY fix. IQ and EZ models show the same fault with CLEAN blue instead of white — see the IQ / EZ Series entry.
Likely causes
- Wheel motor encoder fault
- Encoder cannot read wheel rotation
How to fix it — step by step
- Contact Shark Customer Service at 1-888-228-5531, as the manual directs — there is no user fix listed for this pattern
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
No specific replacement part is documented for this fault. If the checks above do not clear it, the machine likely needs to be disassembled and an internal part replaced - and since the manufacturer publishes no procedure for that, it is the point where most owners hand it to a repair shop.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Shark manual is on Shark's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.