Samsung Robot vacuum Bespoke Jet Bot Combo Something's wrong with the LiDAR bump sensor. The LiDAR cap might be jammed, or there might be something stuck in there.
What this problem usually means
The LiDAR bump sensor needs to be checked.
Likely causes
- LiDAR cap jammed
- Small foreign material between the LiDAR sensor and the main body
How to fix it — step by step
- Press the Reset button to turn it back on
- When the LED blinks red, check for small pieces of foreign material between the LiDAR sensor and the main body
- Remove the foreign material
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Samsung Robot vacuum Bespoke Jet Bot Combo problems
- Something's wrong with the main system. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The 3D sensor needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The AI processor isn't working properly. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The clean water tank of the clean station is empty, so the station can't wash the robot vacuum's Mop. Fill it up with water and start again.
- The clean water tank of the clean station is empty, so the station can't wash the robot vacuum's Mop. Fill it up with water.
- The LIDAR sensor needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The monitoring camera needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The object recognition sensor needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The washing space is full.
- The washing space of the clean station is full, so the station can't wash the robot vacuum's Mop. Empty it.
- The washing space of the clean station is full, so the station can't wash the robot vacuum's Mop. Empty the washing space.
- The wastewater tank of the clean station is full, so the station can't wash the robot vacuum's Mop. Empty it and start again.