Samsung Robot vacuum Bespoke Jet Bot Combo Please check the left wheel to see if there's something stuck in it.
What this problem usually means
Foreign material is caught in the left driving wheel.
Likely causes
- Foreign material caught in the left driving wheel
How to fix it — step by step
- Reset the Jet Bot Combo first (the LED turns white when reset)
- Enable Sleep mode and remove the foreign material from the left driving wheel → Shop the driving wheel at Amazon
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Driving wheel.
Parts that commonly fix it
- Driving wheel - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Samsung manual is on Samsung's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Samsung Robot vacuum Bespoke Jet Bot Combo problems
- Please check the right wheel to see if there's something stuck in it.
- Please insert the battery. If it's already inserted, then turn the power off and back on again to check the battery connection. If you hear this message again after that, contact Customer Service.
- Please insert the bin so cleaning can start.
- Please remove the brush and take out whatever's stuck in there.
- Something is caught in the left Mop.
- Something is caught in the right Mop.
- Something's stuck in the side brush. Please remove it.
- Something's wrong with the cliff sensor. Please clean the 4 small black windows underneath with a soft cloth.
- Something's wrong with the front bump sensors. Please open the cover and check. The bumper might be jammed, or there might be something stuck in there.
- Something's wrong with the LiDAR bump sensor. The LiDAR cap might be jammed, or there might be something stuck in there.
- Something's wrong with the main system. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.
- The 3D sensor needs to be reset. Turn the power off, then on again. If that doesn't fix it, contact Customer Service.