Roborock Robot vacuum Error 21
What this problem usually means
Vertical bumper pressed. The vertical bumper / laser rangefinder bumper at the front of the LiDAR area is pressed in and cannot release.
Likely causes
- Robot wedged against a wall or furniture pressing the vertical bumper
- Debris holding the vertical bumper in
- Object resting against the front sensor housing
How to fix it — step by step
- Move the robot away from the wall or object pressing on it
- Check the vertical bumper and clear any debris around it
- Press and release it to check it moves freely
- Move the robot to an open area and retry
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.