OBD-II Car P0505 Error Code

What the P0505 code means

Idle Air Control (IAC) System Malfunction: the computer detected an incorrect voltage on one or more of the idle air control valve's motor circuits. The IAC valve meters air around the closed throttle plate to hold the correct idle speed; faults show up as stalling at idle, stalling when you lift off the throttle, or an idle that's stuck too high. (On newer drive-by-wire cars there is no separate IAC valve - this code belongs to cable-throttle engines.)

Likely causes

  1. Failed IAC valve - an internal short in one of its motor circuits is typical
  2. Damaged IAC connector - check for bent pins and moisture
  3. Open or shorted IAC wiring between the valve and the PCM
  4. Failed PCM IAC driver (rare - prove it with the unplug test below before condemning the computer)

How to fix it — step by step

  1. Inspect the IAC connector for damaged pins, corrosion, and moisture; repair as needed
  2. Run the isolation test: clear the codes, unplug the IAC valve, and start the engine (ignore any new IAC codes this sets). If P0505 does NOT come back, the valve itself is internally shorted - replace it
  3. If P0505 returns with the valve unplugged, the fault is in the wiring or PCM: inspect the harness back to the PCM for wires shorting together or to ground, and check continuity on each IAC wire
  4. While the valve is off, clean carbon from the IAC pintle and its air passage in the throttle body - a gummed-up valve can mimic an electrical fault
  5. Only replace the PCM if the code still sets with the IAC disconnected and the wiring proven good

Parts that commonly fix the P0505 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →