OBD-II Car P0141 Error Code

What the P0141 code means

Oxygen Sensor Heater Circuit Malfunction (Bank 1, Sensor 2): the heater circuit inside the downstream (after the catalytic converter) oxygen sensor on bank 1 is faulty. This is the same heater fault as P0135 but for the rear sensor. Note that a failed catalytic converter does not cause this code - if the converter were the problem you'd see P0420 instead.

Likely causes

  1. Failed heater element inside the oxygen sensor (open, shorted, or high resistance)
  2. Open or short to ground in the sensor wiring harness
  3. High resistance in the heater circuit wiring or connector
  4. Blown fuse feeding the O2 heater circuit

How to fix it — step by step

  1. Inspect the downstream sensor's connector and wiring - this harness runs close to the exhaust and is often heat- or road-damaged
  2. Check the O2 heater circuit fuse
  3. Measure the heater element resistance at the sensor connector and compare with spec
  4. Replace the bank 1 sensor 2 oxygen sensor if the element tests bad; repair the harness instead if the sensor tests good but power or ground is missing

Parts that commonly fix the P0141 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →