OBD-II Car P0446 Error Code

What the P0446 code means

Evaporative Emission System Vent Control Circuit Malfunction: the vent valve - which closes to seal the EVAP system so the computer can leak-test it - or its control circuit has an electrical fault. The computer sets this code when it sees an open, a short to ground, or a short to battery voltage on the vent valve circuit, or when the system can't achieve or hold vacuum during its test. (Some scan tools mislabel this code as a purge flow fault; the SAE fault is the vent control circuit.)

Likely causes

  1. Faulty EVAP vent valve/solenoid (most likely)
  2. Open, short, or high resistance in the vent valve control or power circuit
  3. Vent valve physically blocked - dirt, dust, or insect nests in the vent filter/hose are common on trucks
  4. Failed PCM driver (rare - rule everything else out first)

How to fix it — step by step

  1. Locate the vent valve (usually at the charcoal canister, under the rear of the vehicle) and inspect it and its fresh-air filter/hose for dirt blockage - clean or clear it
  2. Inspect the connector and wiring for corrosion, rodent damage, and pushed-out pins
  3. Test the valve: it should click when 12V is applied and seal when energised; check its coil resistance against spec
  4. Repair any open, short, or high-resistance wiring you find
  5. Replace the vent valve if it fails the bench test - this is the fix in most cases

Parts that commonly fix the P0446 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related OBD-II car error codes

See all OBD-II car codes & guides →