Neato Robot vacuum Botvac D6 Batt_deep_discharge (message in the Neato app)

What this problem usually means

The battery is deeply discharged / reported dead. Reported in the app on D3 and D7 units on iFixit, and covered for the whole D3-D7 series in a third-party replacement-battery manual - this is NOT in the official Neato D5/D7 user guide, so treat it as a repair-source entry, not an official chart code.

Likely causes

  1. Battery fully drained to 0% / left discharged
  2. Aged / failed battery pack → Shop the battery pack at Amazon
  3. New replacement battery not yet stabilised over charge cycles

How to fix it — step by step

  1. Put the robot on the charge base and allow it to charge fully, even if charging appears to stop and restart; a new battery may need several cycles to stabilise
  2. Do not let the battery drain to 0% - recharge or shut the robot down at 5-10%
  3. If the error will not clear with a known-good battery, seek service from an independent vacuum repair shop (Neato shut down in 2023, so there is no manufacturer service) - do not attempt battery 'jumpstart' tricks described in some third-party guides

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Neato Robot vacuum Botvac D6 problems

See all Neato Botvac D6 codes & guides →