Neato Robot vacuum Botvac Connected Please press OKAY to continue (3000)

What this problem usually means

A numbered 'press OK to continue' error. Cleaners Talk, summarising Neato support guidance, lists this numbered-code family for Botvac Connected and D80/D85 models only, and directs owners through full maintenance and a power cycle; it does not publish a code-by-code meaning for 3000 specifically.

Likely causes

  1. Dirty sensors / laser
  2. Brush, wheel or bumper obstruction
  3. Software / startup fault

How to fix it — step by step

  1. Clean all sensors and the laser, clean the brush, and inspect the wheels and bumper (full general maintenance)
  2. Take the robot off the charge base and power-cycle it: press and hold the Start button for 30 seconds until the lights turn off
  3. Wait up to a minute for the robot to turn back on / play the startup sound, then try again
  4. If the problem persists, take the robot to an independent vacuum repair shop — Neato shut down in 2023, so its Customer Care no longer exists

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related Neato Robot vacuum Botvac Connected problems

See all Neato Botvac Connected codes & guides →