Neato Robot vacuum Botvac 80 Please press OKAY to continue (3000)
What this problem usually means
The robot tries to get ready to start but stops and will not start moving. On iFixit, accepted answers for the Botvac 80 trace this to the laser (LDS) turret not spinning or not reading - a weak/failed LDS motor, a worn LDS drive belt, a dirty/obstructed turret, or a failed laser/board.
Likely causes
- LDS turret not spinning
- Worn LDS drive belt
- Weak / failed LDS motor
- Dirty or obstructed laser turret
- Failed laser unit or main board
How to fix it — step by step
- Clean the laser area with a cotton swab and compressed air
- Check whether the LDS turret spins when starting - gently spin it with a cotton swab and press Start
- If the turret does not spin, inspect / replace the LDS motor or drive belt → Shop the lds drive belt at Amazon → Shop the lds motor at Amazon
- If the turret spins but the error repeats, the laser unit or board may have failed - seek service from an independent vacuum repair shop (Neato shut down in 2023, so there is no manufacturer service)
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the LDS motor.
Also tied to this fault: LDS drive belt - Shop at Amazon
Parts that commonly fix it
- LDS motor - Shop at Amazon
- LDS drive belt - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Neato Robot vacuum Botvac 80 problems
- Please press OKAY to continue. Battery issue (0002)
- Please press OKAY to continue. Battery issue (0003)
- Please press OKAY to continue. Battery issue (0004)
- Please press OKAY to continue. Battery issue (0005)
- Please press OKAY to continue. Battery issue (0006)
- Please press OKAY to continue. Battery issue (0007)
- Please press OKAY to continue. Battery issue (0008)
- Please press OKAY to continue. Battery issue (0009)
- Please press OKAY to continue. Battery issue (8000)
- Please put me down on the floor
- Please wait while I cool down my battery
- Error 4000