Mazda SUV CX-90 Engine fails to restart after i-stop
What this problem usually means
Some CX-90s covered by NHTSA recall 24V816000 may not restart after the i-stop idling stop feature turns the engine off, due to a software issue. An engine that fails to restart at a stop increases the risk of a crash, and dealers reprogram the powertrain control module and battery energy control module software free of charge.
Likely causes
- powertrain control module software fault → Shop the powertrain control module at Amazon
- battery energy control module software fault → Shop the battery energy control module at Amazon
How to fix it — step by step
- Turn off the i-stop feature for each trip if the car has failed to restart until the recall is confirmed done
- Check by VIN whether NHTSA recall 24V816000 applies to the vehicle
- Note whether the failure happened at a stop with i-stop active
- Have a dealer reprogram the PCM and BECM software free of charge under the recall
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the powertrain control module.
Shop the powertrain control module at Amazon
Also tied to this fault: battery energy control module - Shop at Amazon
Parts that commonly fix it
- powertrain control module - Shop at Amazon
- battery energy control module - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.