Maytag Washer Top-Load HE HC Error Code
What the HC code means
The hot and cold inlet hoses have been installed reversed: the cold hose is on the hot inlet and the hot hose is on the cold inlet. The code appears at the end of the wash cycle.
Likely causes
- Hot and cold hoses swapped at installation
- Hoses moved and reconnected incorrectly
How to fix it — step by step
- Turn off the water supply
- Swap the hoses so hot connects to hot and cold to cold
- Turn the water back on and check for leaks
- Run another cycle to verify the code is gone
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix the HC code
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Maytag manual is on Maytag's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.