Maytag Washer Bravos VMW (Top-Load) F7 E5 Error Code
What the F7 E5 code means
Shifter assembly fault: the main control cannot determine the position of the drive system shifter.
Likely causes
- Shifter (actuator) assembly failure → Shop the shifter actuator at RepairClinic
- Loose or damaged wiring between the control board and the shifter
How to fix it — step by step
- Unplug the washer and disconnect power
- Check the wiring harness connections on the main control board and the shifter assembly
- Reconnect any loose wires
- If the wiring is fine, call for service, as the shifter assembly usually needs replacing
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the shifter actuator.
Parts that commonly fix the F7 E5 code
- shifter actuator - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Maytag manual is on Maytag's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.