Maytag Washer Bravos VMW (Top-Load) F3 E1 Error Code
What the F3 E1 code means
Water level pressure sensor fault. The control is not getting a correct water level signal.
Likely causes
- Air hose between the tub and the pressure switch on the control board loose or damaged
- Water level pressure sensor fault on the main control board
How to fix it — step by step
- Unplug the washer and disconnect power
- Check the air hose connection between the bottom of the tub and the control board in the console
- Reconnect or replace a damaged air hose
- If the hose is fine, call for service, as the main control board usually needs replacing → Shop the main control board at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the main control board.
Shop the main control board at RepairClinic or Amazon
Also tied to this fault: pressure sensor hose - Shop at RepairClinic or Amazon
Parts that commonly fix the F3 E1 code
- main control board - Shop at RepairClinic or Amazon
- pressure sensor hose - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Maytag manual is on Maytag's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.