LG Robot vacuum HOM-BOT Turbo+ Robot Cleaner cannot continue cleaning. Please check the area around Robot Cleaner.
What this problem usually means
Warning message given if the Robot Cleaner cannot go on cleaning due to any unfavourable condition.
Likely causes
- The Robot Cleaner is stuck on an obstacle
How to fix it — step by step
- Remove it from the obstacle
- Place the Robot Cleaner back onto the flat floor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related LG Robot vacuum HOM-BOT Turbo+ problems
- Smart Diagnosis has failed to operate.
- The wheels are not touching the floor. Please move Robot Cleaner onto flat floor.
- A problem has been found in the acceleration sensor.
- A problem has been found in the suction motor.
- A problem has been found on the Gyro Sensor.
- A problem has been found on the left wheel sensor.
- A problem has been found on the right wheel sensor.
- Battery is low.
- Charging cannot be done due to a problem in infrared sensor.
- Charging cannot be done due to a problem in the cliff detection sensors on the bottom. Please clean the sensors.
- Charging cannot be done due to a problem in ultrasonic sensor.
- Diagnosis mode cannot be operated due to a low battery.