LG Robot vacuum HOM-BOT Turbo+ Charging cannot be done due to a problem in the cliff detection sensors on the bottom. Please clean the sensors.
What this problem usually means
Smart Diagnosis result: charging cannot be done due to a problem in the cliff detection sensors.
Likely causes
- Cliff detection sensors dirty or faulty
How to fix it — step by step
- Clean the three Cliff Sensors on the bottom at the front of the unit
- Run Smart Diagnosis again; if the same message is announced, contact an LG Electronics service center
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official LG manual is on LG's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related LG Robot vacuum HOM-BOT Turbo+ problems
- Charging cannot be done due to a problem in ultrasonic sensor.
- Diagnosis mode cannot be operated due to a low battery.
- Please check for dirt on the left wheel.
- Please check for dirt on the right wheel.
- Please check if the dust bin is installed with the filter.
- Please check the brushes for obstructions.
- Please remove foreign material on the left/right wheel.
- Please wipe the lower camera sensor on the right bottom of the Robot Cleaner.
- Please wipe the obstacle detecting sensor window on the left and right side of the Robot Cleaner.
- Robot Cleaner cannot continue cleaning. Please check the area around Robot Cleaner.
- Smart Diagnosis has failed to operate.
- The wheels are not touching the floor. Please move Robot Cleaner onto flat floor.