Lennox Furnace 1 + 2 Error Code

What the 1 + 2 code means

On Lennox G61MPV furnaces with the SureLight control, flash code 1 + 2 means low flame current in run mode — the flame signal is weak while the furnace is running.

Likely causes

  1. Dirty or oxidized flame sensor
  2. Poor burner ground
  3. Weak flame from dirty burners

How to fix it — step by step

  1. Replace the air filter and open all registers
  2. Note whether the furnace short-cycles or drops flame mid-cycle
  3. Reset power once and observe a full heat cycle
  4. Call a technician to clean or replace the flame sensor and measure flame current

Parts that commonly fix the 1 + 2 code

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Related Lennox furnace error codes

See all Lennox furnace codes & guides →