Kenmore Washer 110 Series (Whirlpool-Built) Front-Load HE F33 Error Code
What the F33 code means
Pump drive system error on Kenmore 110-series (Whirlpool-built) high-efficiency washers: the connection between the drain pump and the Central Control Unit (CCU) is lost.
Likely causes
- Loose wire harness connection at the pump or control board
- Damaged pump wiring
- Failed drain pump
- Failed central control unit
How to fix it — step by step
- Unplug the washer or disconnect power
- Check the wire harness connections to the pump and to the Central Control Unit and reseat any loose plugs → Shop the drain pump at RepairClinic
- Plug in and run a diagnostic test or any cycle to verify operation
- Call a technician if F33 returns, as the pump or control board needs testing
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Shop the drain pump at RepairClinic or Amazon
Also tied to this fault: main control board - Shop at RepairClinic or Amazon
Parts that commonly fix the F33 code
- drain pump - Shop at RepairClinic or Amazon
- main control board - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 110 Series (Whirlpool-Built) Front-Load HE error codes
See all Kenmore 110 Series (Whirlpool-Built) Front-Load HE codes & guides →