Kenmore Washer 110 Series (Whirlpool-Built) Front-Load HE F21 Error Code
What the F21 code means
Long drain on Kenmore 110-series (Whirlpool-built) high-efficiency front-load washers: drain time exceeds about 8 minutes and the water valves turn off. This is a different platform from the 796 letter codes, where slow drain shows as OE.
Likely causes
- Drain hose kinked, frozen or clogged
- Drain hose raised more than 96 inches or sealed into the standpipe
- Clogged drain pump filter
- Failed drain pump
How to fix it — step by step
- Select PAUSE/CANCEL twice and unplug the washer
- Check the drain hose is not kinked, frozen or clogged and is installed correctly
- Clean the drain pump filter behind the lower front panel → Shop the drain pump at RepairClinic
- Reconnect power and restart; replace the drain pump if it does not run
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the drain pump.
Parts that commonly fix the F21 code
- drain pump - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.
Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.
Related Kenmore Washer 110 Series (Whirlpool-Built) Front-Load HE error codes
See all Kenmore 110 Series (Whirlpool-Built) Front-Load HE codes & guides →