Kenmore Washer 110 Series (Whirlpool-Built) Front-Load HE F20 Error Code

What the F20 code means

No water detected entering the machine on Kenmore 110-series (Whirlpool-built) high-efficiency front-load washers. The pressure switch is not tripped after about 6 minutes of trying to fill.

Likely causes

  1. Water faucets not fully turned on
  2. Plugged or kinked inlet hoses or clogged inlet screens
  3. Failed water inlet valve → Shop the water inlet valve at RepairClinic
  4. Pressure switch hose loose, damaged or a siphon problem if water is in the tub → Shop the pressure switch at RepairClinic

How to fix it — step by step

  1. Select PAUSE/CANCEL twice and unplug the washer
  2. Make sure both faucets are turned on all the way and the inlet hoses are not kinked
  3. Clean the inlet screens and check for frozen hoses in cold weather
  4. Plug in, reselect the cycle and press START; call for service if F20 returns

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix the F20 code

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Kenmore manual is on Kenmore's support site — you'll need your model number.

Find your model number inside the door rim or on the back panel. It's the key to the right manual pages and the right parts.

Related Kenmore Washer 110 Series (Whirlpool-Built) Front-Load HE error codes

See all Kenmore 110 Series (Whirlpool-Built) Front-Load HE codes & guides →