Jeep Truck Gladiator Oil filter housing leak

What this problem usually means

Gladiators with the 3.6L Pentastar commonly need a leaking oil filter housing/cooler replaced, with oil and sometimes coolant pooling in the engine valley under the intake and running down the back of the block. The housing is shared with the JK and JL, and the repair takes about 4-6 hours because the intake manifold has to come off to reach it.

Likely causes

  1. leaking oil filter housing/cooler assembly in the engine valley
  2. ageing housing seals letting oil and sometimes coolant escape

How to fix it — step by step

  1. Check the oil and coolant levels before driving further and top up if low
  2. Look in the engine valley under the intake for pooled oil or coolant, and check the back of the block for runs of fluid
  3. Clean the area and re-check after a short drive to confirm the housing is the source
  4. Replace the oil filter housing/cooler with new seals, refitting the intake with new gaskets → Shop the oil filter housing at Amazon
  5. Refill oil and coolant, bleed the cooling system and confirm no leaks remain

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official Jeep manual is on Jeep's support site — you'll need your model number.

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Jeep Truck Gladiator problems

See all Jeep Gladiator codes & guides →