iRobot Robot vacuum Roomba 600 Series Clunking sound while cleaning
What this problem usually means
A repeated clunking or clacking noise from the brush deck while cleaning. The 600 series uses the same Cleaning Head Module (CHM) design as the 500 series, and the noise comes from friction in the CHM: the anti-tangle routine keeps reversing the brush motor when the brushes meet too much resistance. Packed debris in the gearbox, worn brush bearings, or worn gear teeth are the usual sources.
Likely causes
- Hair and debris packed inside the CHM gearbox, loading the brush motor
- Dust-packed or worn brush bearings binding
- Hair wound under the brush-end bearings
- A worn CHM gearbox with rounded gear drive sockets
How to fix it — step by step
- Remove the brushes and clean all hair and debris from the brush ends and bearings; run the robot without the brushes to confirm the noise is in the brush deck, not the wheels
- Remove the Cleaning Head Module from the robot: turn the robot over, remove the bottom plate, then remove the four screws holding the cleaning head module and lift the module out → Shop the cleaning head module (chm) at Amazon
- Open the gearbox on the module: remove the screws around the gearbox cover - there are roughly eight to ten of them - and lift the cover off
- Remove the gears and inspect them for broken or worn teeth and packed debris; clean out the old grease, re-grease the gears, and free or replace stiff bearings
- Replace the Cleaning Head Module if the noise persists with a clean, free-spinning deck
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Cleaning Head Module (CHM).
Shop the Cleaning Head Module (CHM) at Amazon
Also tied to this fault: White lithium grease - Shop at Amazon
Parts that commonly fix it
- Cleaning Head Module (CHM) - Shop at Amazon
- White lithium grease - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: documented owner repair reports. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.