iRobot Robot vacuum Roomba 600 Series Charging Error 3

What it should look like on your machine

then it repeats

3 blinks - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Charging error shown by 3 blinks (display Err3) while charging: Roomba has a charging error. The 600 Series manual gives no more specific cause.

Likely causes

  1. Unspecified charging error (manual wording)

How to fix it — step by step

  1. Reset Roomba's software by simultaneously holding down the two buttons above and below CLEAN for 10 seconds
  2. Try charging again

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot vacuum Roomba 600 Series problems

See all iRobot Roomba 600 Series codes & guides →