iRobot Robot vacuum Roomba 500 Series Clunking sound while cleaning

What this problem usually means

A repeated clunking or clacking noise from the brush deck while cleaning. On the 500 series the noise comes from the Cleaning Head Module (CHM): the anti-tangle routine keeps reversing the brush motor when the brushes meet too much resistance, and that reversing is the clunk you hear. The resistance itself comes from the CHM - debris packed in the gearbox, dry or worn brush bearings, hair wound tight under the brush ends, or worn gear teeth.

Likely causes

  1. Hair and debris packed inside the CHM gearbox, loading the brush motor
  2. Dust-packed or worn brush bearings (including the yellow brush-end bearings) binding
  3. Hair wound under the brush-end bearings making the brushes knock ('clack clack')
  4. A worn CHM gearbox (gear hubs and square drive sockets rounding out) or a first-version flexible brush defect
  5. A Cleaning Head Module at the end of its life - once the gears and drive sockets are worn, replacement is the fix

How to fix it — step by step

  1. Remove the brushes and clean all hair and debris from the brush ends and the yellow bearings; run the robot without the brushes to confirm the noise is in the brush deck, not the wheels
  2. Remove the Cleaning Head Module from the robot: turn the robot over, remove the bottom plate, then remove the four screws holding the cleaning head module and lift the module out → Shop the cleaning head module (chm) at Amazon
  3. Open the gearbox on the module: remove the screws around the gearbox cover - there are roughly eight to ten of them - and lift the cover off
  4. Remove the gears and inspect them for broken or worn teeth and packed debris; clean the old grease and debris out of the gearbox housing
  5. Check the square drive sockets for rounding or melting while the gearbox is open; worn sockets or damaged gears will keep overloading the brush motor
  6. Re-grease the gears, rebuild the module, refit it and the bottom plate, and test; if the clunking persists with a clean, free-spinning deck, replace the Cleaning Head Module

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: documented owner repair reports. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot vacuum Roomba 500 Series problems

See all iRobot Roomba 500 Series codes & guides →