iRobot Robot vacuum Dirt Dog Uh-oh + 5 beeps
What it should sound like on your machine
then it repeats
5 beeps - then the pattern repeats. Count along with your machine and compare.
What this problem usually means
Dirt Dog plays the two-tone 'uh-oh' sound followed by 5 beeps: the cliff sensors have failed or are blocked.
Likely causes
- Debris caught underneath the front bumper in the cliff sensors, blocking them
- The cliff sensors have failed
How to fix it — step by step
- Turn over Dirt Dog and clear any debris that might be caught underneath the front bumper in the cliff sensors
- Use compressed air to clean the cliff sensors out
- If the error persists with clean sensors, the manual's chart header directs you to iRobot support (www.irobot.com/support)
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.