iRobot Robot vacuum Dirt Dog Uh-oh + 1 beep

What it should sound like on your machine

then it repeats

1 beep - then the pattern repeats. Count along with your machine and compare.

What this problem usually means

Dirt Dog plays the two-tone 'uh-oh' sound followed by 1 beep: the main brushes cannot turn.

Likely causes

  1. An obstruction stopping the main brushes from turning
  2. Hair or debris wrapped around the brushes or brush bearings (the manual's Maintenance section warns that excessive build-up in the brushes and bearings can stall and damage Dirt Dog)

How to fix it — step by step

  1. Turn over Dirt Dog and remove the brush guard by pushing the two yellow tabs
  2. Remove the brushes and clear any obstructions
  3. Replace the brushes again (see the manual's Maintenance section for brush and bearing cleaning) → Shop the main brushes at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Working on a specific model? The official iRobot manual is on iRobot's support site — you'll need your model number.

Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.

Related iRobot Robot vacuum Dirt Dog problems

See all iRobot Dirt Dog codes & guides →