iRobot Dirt Dog Common Problems
Find your problem in the list below. Each page explains the most likely causes, step-by-step checks you can do yourself, when to call a pro, and the parts that commonly resolve it. 10 problems covered.
Shop iRobot Dirt Dog parts at Amazon
Not sure of the code? Tap along with it
If your iRobot Robot vacuum blinks or beeps a pattern instead of showing a code, tap the button in time with each blink or beep. A pause longer than a second and a half starts a new group - we will match the rhythm to a code.
Your rhythm: -
- Circle dance (spins in circles) — Dirt Dog spins in circles instead of sweeping. On Dirt Dog the usual cause is a wheel tachometer sensor blocked by dust - Dirt Dog has no…
- Stops, plays dead-battery tune, then runs again — Dirt Dog starts, stops after a short run and plays the dead-battery tune, then will run again - even with batteries that test good in…
- Uh-oh + 1 beep — Dirt Dog plays the two-tone 'uh-oh' sound followed by 1 beep: the main brushes cannot turn.
- Uh-oh + 10 beeps — Dirt Dog plays the two-tone 'uh-oh' sound followed by 10 beeps: Dirt Dog is stuck.
- Uh-oh + 2 beeps — Dirt Dog plays the two-tone 'uh-oh' sound followed by 2 beeps: the side brush cannot turn.
- Uh-oh + 4 beeps — Dirt Dog plays the two-tone 'uh-oh' sound followed by 4 beeps: a wheel motor cannot run.
- Uh-oh + 5 beeps — Dirt Dog plays the two-tone 'uh-oh' sound followed by 5 beeps: the cliff sensors have failed or are blocked.
- Uh-oh + 6 beeps — Dirt Dog plays the two-tone 'uh-oh' sound followed by 6 beeps: a wheel obstruction, or Dirt Dog is attempting to drive over an obstacle.
- Uh-oh + 9 beeps — Dirt Dog plays the two-tone 'uh-oh' sound followed by 9 beeps: a sensor error. The manual's chart gives no user fix for this code - it says…
- Uh-oh + no beeps — Dirt Dog plays the two-tone 'uh-oh' sound with no beeps after it: a wheel is stuck or is not touching the ground.