Hyundai Sedan Elantra Transmission Slipping

What this problem usually means

Elantras that gained Hyundai's IVT (its chain-driven CVT) — the refreshed 2019-2020 2.0L cars and the 2021-on CN7 generation — can slip, surge or flare RPM without gaining speed, and early IVT cars failed at unusually low mileage, sometimes under 30,000 miles. Hyundai issued TCM reprogramming campaigns, but a chain that has already slipped and scored the pulleys is a replacement unit, not a software fix.

Likely causes

  1. IVT drive chain slipping on the pulleys under load
  2. IVT fluid degradation or low fluid level
  3. Transmission control module calibration (early IVT cars) → Shop the transmission control module at Amazon
  4. Launch torque converter fault on later IVT cars

How to fix it — step by step

  1. Confirm which transmission your car actually has — 6-speed automatic, IVT or DCT — because the diagnosis and fluid are completely different
  2. Scan the TCM for codes such as incorrect gear ratio and record when the slip happens (cold, hot, highway, pulling away)
  3. Ask a dealer to check for TCM software campaigns for your VIN before paying for diagnosis
  4. Have the IVT fluid serviced with the correct Hyundai CVT fluid if it is overdue; if slipping continues with good fluid and current software, the unit itself is failing and is normally replaced, not rebuilt → Shop the cvt fluid at Amazon

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related Hyundai Sedan Elantra problems

See all Hyundai Elantra codes & guides →