Hyundai Sedan Elantra Engine knocking noise on cold start
What this problem usually means
Certain 2011-2016 Elantras with the 1.8L Nu engine can develop piston-slap-related short-block damage that shows up as persistent engine noise on a cold start, and certain 2014-2016 cars with the 2.0L GDI engine are covered by a connecting-rod bearing program. Hyundai runs defined special-coverage programs (TXXK and TXXM) for these two different conditions.
Likely causes
- piston slap and short-block damage on the 1.8L Nu engine
- connecting-rod bearing wear on the 2.0L GDI engine
How to fix it — step by step
- Listen on a fully cold start, before the engine has been warmed up - a quiet warm engine does not settle it
- Check the oil level and top up only with the specified oil if it is low
- Stop driving and arrange a tow if the knock gets louder with rpm or the oil light comes on
- Have a shop verify the engine fitted, check knock-detection campaign completion and confirm special-coverage eligibility by VIN
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
This fault usually needs a technician - but this is the part they would test first.
Then the likely broken part is the connecting rod bearings.
Shop the connecting rod bearings at Amazon
Also tied to this fault: piston rings - Shop at Amazon
Parts that commonly fix it
- connecting rod bearings - Shop at Amazon
- piston rings - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.