Honeywell Air purifier HPA600 PREFILTER Light Illuminated

What this problem usually means

Check Filter Indicators guide: when the 'PREFILTER' light is illuminated, it is time to clean (vacuum or wash) the 2 permanent mesh pre-filters, which are located on each side of the purifier at the air intake and capture larger particles such as dust and pet hair/fur. The pre-filters should be cleaned every 3 months.

Likely causes

  1. Mesh pre-filters are due for their approximately 3-month cleaning
  2. Electronic filter check timer, based on hours of use, has expired

How to fix it — step by step

  1. Power OFF and unplug the air purifier - you will have to remove the two HEPA Z filters to access the mesh pre-filters → Shop the mesh pre-filter at Amazon
  2. Grasp the plastic tab(s) on each mesh pre-filter and gently pull inward and out of the unit, clearing the metal retention tabs
  3. Shake or vacuum the pre-filters clean, or rinse them by hand under warm water, and let them air dry completely before re-installing
  4. Return the clean, dry pre-filters to the same location, securing them behind the metal retention tabs, and re-install the HEPA filters
  5. Plug the unit in, tap the power icon, then press and hold the reset icon next to the illuminated PREFILTER indicator for 2-3 seconds - a chime will sound and the light will flash for 3 seconds and then shut off, showing the timer has been reset

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Honeywell Air purifier HPA600 problems

See all Honeywell HPA600 codes & guides →