Honeywell Air purifier HPA600 FILTER Light Illuminated
What this problem usually means
Check Filter Indicators guide: this Professional Series purifier has two electronic filter checks based on hours of use. When the 'FILTER' light is illuminated, replace the 3-in-1 True-HEPA Z filters - this model requires two of them, and it is recommended they be replaced every 12 months.
Likely causes
- 3-in-1 True-HEPA Z filters have reached the end of their approximately 12-month life
- Electronic filter check timer, based on hours of use, has expired
How to fix it — step by step
- Power OFF and unplug the air purifier, open the rear door and remove and dispose of the used filters - the 3-in-1 HEPA Z filters are not washable and must not be immersed in water
- Install two new 3-in-1 HEPA Z filters with the red pull tabs facing outward and the black carbon-granule side and foam seal facing in to the purifier housing, then close the rear door
- Plug the unit into the power outlet and tap the power icon to turn it on
- Press and hold the reset icon next to the illuminated FILTER indicator for 2-3 seconds - a chime will sound and the indicator light will flash for 3 seconds and then shut off, showing the timer has been reset
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the Honeywell 3-in-1 HEPA Replacement Filter Pack Z HRF-Z2.
Shop the Honeywell 3-in-1 HEPA Replacement Filter Pack Z HRF-Z2 at Amazon
Parts that commonly fix it
- Honeywell 3-in-1 HEPA Replacement Filter Pack Z HRF-Z2 - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.