Honeywell Air purifier HPA600 Particle Sensor Cleaning
What this problem usually means
Cleaning the Particle Sensor guide: the Particle Sensor is located in a compartment on the right side of the purifier above the air intake grille, and the manual recommends cleaning it every 3 months to optimize performance. The Air Quality Indicator on this model is driven by its Particle and VOC Sensors (blue = good, amber = medium, red = poor).
Likely causes
- Debris builds up in the particle sensor openings
- Sensor has not been cleaned at the recommended 3-month interval
How to fix it — step by step
- Use your thumb to open the Particle Sensor Door on the right side of the purifier, above the air intake grille
- Use a dry cotton swab to clean the three openings shown in the manual of any debris
- Do NOT use any cleaners or liquids on the particle sensor
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.