Honeywell Air purifier HPA100 / HPA200 / HPA300 Noise and Reduced Air Output
What this problem usually means
Frequently Asked Questions entry: the air purifier is starting to make noise and the air output is less.
Likely causes
- The filters may be dirty - high amounts of contaminants can block the pores in the filter and stop air from moving through it
How to fix it — step by step
- Check the HEPA filter(s) and pre-filter
- Replace the filters - Certified HEPA Filters every 12 months and Odor Reducing Pre-Filters every 3 months → Shop the odor reducing pre-filter hrf-ap1 at Amazon
- Reset the electronic filter check after replacing the filters by holding the lighted Check Filter or Check Pre-Filter button for approximately 2 seconds with the unit powered on
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the HEPA Replacement Filter HRF-R1 / HRF-R2 / HRF-R3.
Shop the HEPA Replacement Filter HRF-R1 / HRF-R2 / HRF-R3 at Amazon
Also tied to this fault: Odor Reducing Pre-Filter HRF-AP1 - Shop at Amazon
Parts that commonly fix it
- HEPA Replacement Filter HRF-R1 / HRF-R2 / HRF-R3 - Shop at Amazon
- Odor Reducing Pre-Filter HRF-AP1 - Shop at Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.