Honeywell Air purifier HPA100 / HPA200 / HPA300 Check Pre-Filter

What this problem usually means

Electronic Filter Change Reminder: the 'Check Pre-Filter' light illuminates when it is time to replace the Odor Reducing Pre-Filter, based on the air purifier's hours of use. Odor Reducing Pre-Filters should be replaced every 3 months, more often if there have been heavy odors and particles in the home.

Likely causes

  1. Odor Reducing Pre-Filter has reached the end of its approximately 3-month life
  2. Electronic filter check timer, based on hours of use, has expired
  3. Heavy odors and particles have loaded the pre-filter early

How to fix it — step by step

  1. Turn the unit OFF and unplug it, remove the front grille, and remove and dispose of the used pre-filter - none of the filters on this model are washable and they must not be immersed in water
  2. Install a new Type A Odor Reducing Pre-Filter on top of the HEPA filter(s), tucking its edges into the designated tabs, then replace the front grille → Shop the odor reducing pre-filter hrf-ap1 at Amazon
  3. With the unit powered ON, press the lighted 'Check Pre-Filter' button and hold for approximately 2 seconds until the light turns off - the electronic filter check is now reset
  4. Early-reset note from the manual: if you change the pre-filter before its light is illuminated, with the unit plugged in but NOT powered on, press and hold the button for at least 5 seconds until the light illuminates, then press and hold it again until the light goes off

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Honeywell Air purifier HPA100 / HPA200 / HPA300 problems

See all Honeywell HPA100 / HPA200 / HPA300 codes & guides →