Honeywell Air purifier HPA100 / HPA200 / HPA300 Check Filter

What this problem usually means

Electronic Filter Change Reminder: the 'Check Filter' light illuminates when it is time to replace the Certified HEPA Filter(s), based on the air purifier's hours of use. Certified HEPA Filters should be replaced every 12 months. HPA100/HPA090 use 1 HEPA filter, HPA200 uses 2 and HPA300 uses 3.

Likely causes

  1. Certified HEPA Filter(s) have reached the end of their approximately 12-month life
  2. Electronic filter check timer, based on hours of use, has expired

How to fix it — step by step

  1. Turn the unit OFF and unplug it, remove the front grille, and remove and dispose of the used HEPA filter(s)
  2. Remove the protective wrap from the new Certified HEPA Filter(s) and place them into the housing with the pull tabs facing outward, then replace the pre-filter and front grille
  3. With the unit powered ON, press the lighted 'Check Filter' button and hold for approximately 2 seconds until the light turns off - the electronic filter check is now reset
  4. Early-reset note from the manual: if you change a filter before its light is illuminated, with the unit plugged in but NOT powered on, press and hold the button for at least 5 seconds until the light illuminates, then press and hold it again until the light goes off

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.

Related Honeywell Air purifier HPA100 / HPA200 / HPA300 problems

See all Honeywell HPA100 / HPA200 / HPA300 codes & guides →