Hayward Pool heater HeatPro PS Error Code
What the PS code means
On Hayward HeatPro heat pump pool heaters, PS indicates improper water flow or insufficient water pressure - the water pressure switch contacts have not closed.
Likely causes
- circulation pump off or low flow
- dirty filter or clogged baskets
- closed or partly closed valves
- water pressure switch needing adjustment or replacement → Shop the water pressure switch at RepairClinic
How to fix it — step by step
- Make sure the filter pump is running
- Clean or backwash the filter and empty skimmer and pump baskets
- Open all valves to the heat pump fully
- Confirm strong flow, then restart the heat pump
- If PS persists with good flow, call a pool/spa technician about the pressure switch
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the water pressure switch.
Parts that commonly fix the PS code
- water pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.