Hayward Pool heater HeatPro LP Error Code
What the LP code means
On Hayward HeatPro heat pump pool heaters, LP indicates low refrigerant pressure, which can be caused by loss of refrigerant, fan motor failure, evaporator freeze-up, airflow blockage, or outside air that is too cold (usually below about 45-55F).
Likely causes
- low outside air temperature
- airflow blockage or dirty evaporator coil
- fan motor failure → Shop the fan motor at RepairClinic
- loss of refrigerant
How to fix it — step by step
- Check the outside temperature - if it is cold, wait for warmer air and let any coil frost melt with power off
- Clear leaves and debris from around and on the evaporator coil without bending fins
- Make sure the fan can spin freely and the unit has clear airflow
- Restart once after conditions improve
- If LP returns in mild weather, call a technician - do not add refrigerant yourself
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the low pressure switch.
Shop the low pressure switch at RepairClinic or Amazon
Also tied to this fault: fan motor - Shop at RepairClinic or Amazon
Parts that commonly fix the LP code
- low pressure switch - Shop at RepairClinic or Amazon
- fan motor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.