Hayward Pool heater HeatPro VS E05 Error Code
What the E05 code means
On Hayward HeatPro VS heat pump pool heaters, E05 is water temperature freeze protection - the unit detected a water freeze warning condition.
Likely causes
- water temperature near freezing
- low water flow in cold weather
- very low ambient temperature
How to fix it — step by step
- Keep the circulation pump running continuously during freezing weather
- Confirm full water flow through the heat pump - clean filter and open valves
- Do not shut the system down in a freeze unless you fully drain it per the manual
- If E05 persists after temperatures rise and flow is good, call a pool/spa technician
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flow switch.
Shop the flow switch at RepairClinic or Amazon
Also tied to this fault: temperature sensor - Shop at RepairClinic or Amazon
Parts that commonly fix the E05 code
- flow switch - Shop at RepairClinic or Amazon
- temperature sensor - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.