Hayward Pool heater HeatPro VS E03 Error Code
What the E03 code means
On Hayward HeatPro VS heat pump pool heaters, E03 means the flow switch circuit is open - low or no water flow, or a remote on/off in use.
Likely causes
- low or no water flow
- circulation pump off
- dirty filter or closed valves
- failed flow switch
How to fix it — step by step
- Make sure the circulation pump is running
- Clean or backwash the filter and clear all baskets
- Open valves to the heat pump fully and close any bypass diverting flow away
- Restart the heat pump once flow is strong
- If E03 persists with good flow, call a pool/spa technician about the flow switch → Shop the flow switch at RepairClinic
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the likely broken part is the flow switch.
Shop the flow switch at RepairClinic or Amazon
Also tied to this fault: water pressure switch - Shop at RepairClinic or Amazon
Parts that commonly fix the E03 code
- flow switch - Shop at RepairClinic or Amazon
- water pressure switch - Shop at RepairClinic or Amazon
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Working on a specific model? The official Hayward manual is on Hayward's support site — you'll need your model number.
Find your model number on the unit's rating plate. It's the key to the right manual pages and the right parts.