GMC SUV Yukon Hard brake pedal

What this problem usually means

On 2015-2018 Yukons (the pump design runs through 2020), a brake pedal that turns hard with longer stopping distances points to the engine-driven vacuum pump losing output as it wears. Recall 19V645000 reprograms the brake control module so hydraulic assist backs up a weak pump, and special coverage N182202780 pays for a replacement pump for 10 years/150,000 miles where the VIN is listed. This is a safety system: do not keep driving on a hard pedal.

Likely causes

  1. Worn engine-driven vacuum pump reducing booster assist → Shop the vacuum pump at Amazon
  2. Vacuum pump drive belt failure → Shop the vacuum pump belt at Amazon
  3. Vacuum hose leak between the pump and the booster
  4. Brake booster failure, less common than the pump on these Yukons

How to fix it — step by step

  1. Stop driving the Yukon if the pedal is hard and stopping distances have grown
  2. Check your VIN at nhtsa.gov/recalls for 19V645000 and confirm the brake module software update was done
  3. Ask a GMC dealer whether special coverage N182202780 applies to your VIN, since a confirmed pump failure may be replaced free
  4. Have pump output and the pump belt inspected; a snapped belt imitates a dead pump
  5. Pump replacement is brake-system work for a dealer or qualified shop

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related GMC SUV Yukon problems

See all GMC Yukon codes & guides →