GMC SUV Yukon Engine stalls and won't restart

What this problem usually means

Some 2022 Yukons and Yukon XLs can stall or crank without starting when the frame-mounted fuel pump power control module fails and interrupts fuel flow to the engine. GM voluntary emission recall N262558690 was expanded in September 2026 to add the 2022 Yukon, and dealers replace the module free on covered vehicles. Because it is an emission recall rather than a safety recall, check the GMC owner site too, not just the NHTSA lookup.

Likely causes

  1. Failed fuel pump power control module (recall N262558690) → Shop the fuel pump power control module at Amazon
  2. Fuel pump failure inside the tank
  3. Corroded module connector or ground at the frame rail
  4. Weak battery or starter fault mimicking a no-fuel no-start

How to fix it — step by step

  1. Note the pattern: normal cranking with no start, or a stall followed by a no-start, points to fuel delivery
  2. Listen for the fuel pump priming at the filler neck when the ignition is turned on; silence supports a pump power fault → Shop the fuel pump at Amazon
  3. Ask a GMC dealer to check your VIN for N262558690 by number, and check the GMC owner site's recall page as well
  4. Have the module tested before authorizing a fuel pump replacement; the module is the recalled part
  5. If the campaign applies, the dealer replaces the module at no charge; keep the repair order

Did that fix it?

Worked through the steps? Say where you landed - it pinpoints what to do next.

Parts that commonly fix it

What fixed yours?

Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.

Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.

Manual & model number

Find your model number in the owner's manual and on the driver-door jamb label. It's the key to the right manual pages and the right parts.

Related GMC SUV Yukon problems

See all GMC Yukon codes & guides →