Ecovacs Robot vacuum Deebot Ozmo T8 DEEBOT is not able to connect to the home Wi-Fi network
What this problem usually means
The robot cannot join the home Wi-Fi, so app control fails.
Likely causes
- Incorrect home Wi-Fi username or password entered
- Incorrect App installed
- DEEBOT is not within range of your home Wi-Fi signal
- Network setup was started before DEEBOT was ready
- DEEBOT does not support 5 GHz Wi-Fi
How to fix it — step by step
- Enter the correct home Wi-Fi username and password
- Download and install the ECOVACS HOME App
- Make sure DEEBOT is within range of your home Wi-Fi signal
- Turn ON the Power Switch and press the RESET Button; DEEBOT is ready for network setup when its Wi-Fi Indicator light flashes slowly
- Connect the robot to a 2.4 GHz Wi-Fi network
Did that fix it?
Worked through the steps? Say where you landed - it pinpoints what to do next.
Good - you're done. If it comes back, the causes at the top of this page are where to look first.
Then the fault is internal - there is no documented owner fix beyond the steps above. If you're not comfortable opening the machine up, a repair shop is the next step.
Parts that commonly fix it
This fault usually does not need a replacement part - the fix is in the steps above. If your machine does need a part, start with the link above.
What fixed yours?
Fixed this on your machine? Tap what did it - reports from owners set the percentages on this page.
Source: manufacturer / repair documentation. Codes can vary by model — confirm against your manual.
Manual & model number
Find your model number on the underside label or in the app. It's the key to the right manual pages and the right parts.
Related Ecovacs Robot vacuum Deebot Ozmo T8 problems
- DEEBOT is not charging
- DEEBOT misses cleaning spots to be cleaned, or repeats cleaning the area cleaned
- DEEBOT returns to the Docking Station before it has finished cleaning
- The water is not coming out of the Reservoir when DEEBOT is mopping
- AIVI Visual Detection Sensor cannot recognize objects
- AUTO Mode Button flashes RED
- AUTO Mode Button glows a solid RED (low battery)
- DEEBOT cannot return to the Docking Station
- DEEBOT does not clean automatically at the scheduled time
- DEEBOT gets stuck while working and stops
- DEEBOT is making too much noise when cleaning